Hi,
I try to implement the following scenario:
boots -> process a task in ACTIVE mode for exectly 2 sec -> deep sleep for 5 sec -> task for 2 sec -> deep sleep 5 sec and so on.
This works great with WDT (wakeup from deep sleep after counting WDT intervals until 5 sec are reached) and a one shot timer (to time the 2 sec task duration).
But if I add BLE functionality into the design, something does not fit any more. I invested already two days into it, and read of course all the available PDFs (BLE getting started + Low-Power Modes and Power Reduction Techniques) , I analised the LPM example project but it uses the WDT differently then me.
I prepared a use case project (with oth) to analyse the problem, which uses LEDs and UART for logging.
So without BLE, where everything is fine, the following expected LED sequence can be observed:
GREEN (task) for 2 sec
BLUE (deep sleep) for 5 sec
during BLUE phase above 4 WHITE flashes every 1 sec (WDT interval ticks, reentering deep sleep)
end of BLUE phase above 1 WHITE double flash (wake up from deep sleep)and so on...
UART logs the following sequence, (the single point after each WDT tick stays for reentering deep sleep mode).
Do something...
Try to sleep...WDT tick: 1
.
WDT tick: 2
.
WDT tick: 3
.
WDT tick: 4
.
WDT wakeup
Now if I enable BLE (un-comment #define ENABLE_BLE in main.h), I observe the following pattern
GREEN for 2 sec
GREEN for 2 sec
BLUE flickering for about 3 sec
during BLUE phase above 2 WHITE flashes every 1 sec (WDT interval ticks, reentering deep sleep)
end of BLUE phase above 1 WHITE double flash (wake up from deep sleep)and so on...
UART logs the following sequence
Do something...
Try to sleep...
Update GATT database...
Do something...
Try to sleep...WDT tick: 2
....................................................
WDT tick: 3
..............................................................................
WDT tick: 4
.............................................................................
WDT wakeup
One can see many single points between WDT ticks, so the program tries reentering deep sleep very often but stays there only for a short time. I suppose it is because of the BLE subsystems interrupts, which would be fine if the average power savings were OK which I did not measure now. Am I correct with this assumption? How can I tune the intervals here, I did not catch this in the docs.
But what really bothers me is the fact, that work phase (GREEN) occurs twice without any sleep phase between, and that the deep sleep phase itself is shorter as expected (something above 2 sec instead of 5).
Eventually the program crashes after some time sooner or later. I am not experienced enough yet to debug this :-)
Why does BLE interfere with the WDT timer so radically? I would expect, that the WDT does it work in background without any distortions using LFCLK. Giving WDT higher interrupt priority than BLESS or changing the LFCLK source from WCO to ILO does not make any difference in the pattern.
Is there anything I can do to fix my design? I will appreciate any optimizations.
What can I do to better understand the BLE low power behavior?
My project is attached to this post.
Thx
